The basic jaw of movable rigidity is to clamp the superlarge workpiece in different clamping point or three-point clamping device
The front of all the basic jaws is ground and therefore suitable for processing semi-finished products
“Controlled by a general
Basic unit has positioning hole, support
There’s also a round handle. This is screwfastened
With a
MH10 screw.
Not part of it. 2305/000
Control of general/control of 2306/001 wheel control.
Because of its special shape, the pressure of the eye can be reduced by applying clamping force – especially when clamping workpieces are needed.
2306/001
2306/002
2306/003
The parts are clamped together for shape
Grip height: adjustable 4.5 ~ 6.0 mm
It’s very high
Not part of it. 2301/000
The parts are clamped together for shape
Height of grip: adjustable from 3.0 to 4.5mm
Minimum holding side loss
Not part of it. 2304/000
Used for holding semi-finished products, smooth clamping surfaces
Under the effect of carbide coating, friction adhesion is enhanced
Maintaining force increases a factor of approximately. 1.8
Not part of it. 2302/000
The parts are clamped together for shape
Support height 6.0 mm; That is, drilling through the underside of the workpiece
Not part of it. 2303/000
Support high
Control height
support
plate
ground
The lowest (0) min. 18
Max. 40 and Max.
Max. Jn. 120
As a result of modular design, in the case of using the basic jaw hole pattern, can handle the rotation of the function and the tip of the handle (need customer support) is introduced into any position relative to the workpiece. By applying clamping force the tip of the handle pushes it into the material, resulting in a positive fi t.
The height of the fixture height and the support height of the workpiece can be changed by adjusting the different assembly parts. The new high feed insertion improves the roughing ability of small diameter applications
